User Tools

Site Tools


GPi case

Starting with batocera.linux 5.23, the Retroflag GPi case is supported out of the box.

While the 5.23 version is not yet out, you can find a stable pre-image available here :
Once installed, you should not use the upgrade feature until 5.23 is out, because batocera.linux
upgrade behavior is to move to the last official stable, in other words, it will downgrade your system to 5.22
which will break the GPi case suuport


Install this image on a sdcard as any version of batocera.linux (there is no special image for the GPi case it is the same image as the rpi1 image).

The only difference is that once batocera.linux is copied on the sdcard, you've to remove the file config.txt on the top of the sdcard and rename the file config_gpicase.txt to config.txt.

That's all.

en/retroflag_gpicase.txt · Last modified: 2019/06/21 07:59 by nadenislamarre